Pet Mice Forum banner
1 - 14 of 14 Posts

· Registered
Joined
·
249 Posts
Discussion Starter · #1 ·
I am building some tubs tonight for my mice, and one of the previous ones i made had the zip tie ends on the outside, and mad it very unattractive, and hard for me to handle would it be bad for the mice if i put the ends on the inside? the panels are on the sides not on the top...
 

· Registered
Joined
·
2,977 Posts
If you're worried about it, you can always file them down after you clip them. Or heat them slightly with a lighter, so that the sharp edges get melted into a more rounded edge.

But honestly, you're fine without that. :lol:
 

· Registered
Joined
·
1,070 Posts
Ditto - mine has been a godsend. I even use my soldering iron to make holes in margarine and ice cream tubs to make beds for my mice and cheap destructible toys for my multis. I wish I could have got one cheap though - it cost me £20 ($29) :shock: !!
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top