Pet Mice Forum banner
1 - 2 of 20 Posts

· Registered
22 Posts
I converted my first two RUB's last night, and I have to say, what a palava!!!! :shock:

I used a soldering iron to make holes in the lid, and then a jigsaw to to cut the lid off. The first one was fine, but the jigsaw obviously makes the plastic melt, so the cut out bit of the lids gets kind of stuck in although it's cut out, and when I pushed it out i wasn't that careful, so the plastic splintered a bit. It was still usable though.

I got my teenage son to help with all the tie wraps, it was soul destroying! :)

One question though. I got my mesh from B&Q and the holes are 13mm x 13mm. Will the mice escape from that?! :?
1 - 2 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.